ARToolkit question: calib-camera2

Discussion relating to the open-source GPL-licensed ARToolKit v2.x.

Moderator: ARToolKit developers

ARToolkit question: calib-camera2

Postby occamjmv » Fri Jan 13, 2012 3:01 am

Hi,

I have trouble running the "one-step" calibration routine of ART (this is for a student project I teach).
The procedure goes as documented, no problem... except at the end, I have no idea where the parameters
are saved, or even if they are saved at all ? The doc says to do the same as "step 1" of the lengthy procedure...
except that in the 2-step procedure, the params are saved at the very end of step 2 !

I'm very familiar with camera calibration, but I'm confused by the poor documentation of ARToolkit procedure.

Any help on how to save a decent .dat file after a one-step calibration procedure ?

thanks !

jm.
occamjmv
 
Posts: 1
Joined: Fri Jan 13, 2012 2:42 am

Re: ARToolkit question: calib-camera2

Postby ghovagimyan » Mon Jul 16, 2012 6:41 am

I have a similar question/problem. I'm on OSX. I'm using the open source version and I'm looking for the first calib_camera folder. I can't find it on git-hub etc..
ghovagimyan
 
Posts: 1
Joined: Mon Jul 16, 2012 6:35 am

Re: ARToolkit question: calib-camera2

Postby DeboraLee » Wed Oct 15, 2014 9:39 pm

I'm very familiar with camera calibration, but I'm confused by the poor documentation of ARToolkit procedure.
jEMI
DeboraLee
 
Posts: 1
Joined: Wed Oct 15, 2014 9:16 pm


Return to ARToolKit (v2.x)

Who is online

Users browsing this forum: No registered users and 1 guest

cron